2. INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will
reduce the possibility of a malfunction in the cooling system from improper handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION SPECIFICATIONS
•
This appliance requires a standard 115 Volt A.C. /50Hz electrical outlet with three-prong ground
。
•
This
appliance is designed to be
installed built-in or free standing
.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Ambient
temperature below 68°F (20°C) or above 90°F (32°C) will hinder the performance of this appliance.
This
unit is not designed for use in a garage or any other outside installation.
•
Avoid locating the appliance in moist areas.
•
Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized Service Center.
This unit is
not designed to be installed in an RV or used with an inverter.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 3 ~ 4 hours before placing
wine bottles in the appliance.
•
This wine cooler come with adjustable legs (in the front) to help level the unit
BUILT-IN INSTALLATION
The cutout dimension illustrated in figure (A) allows for door swing and access to the pull-out shelves when
installed as a built-in appliance. If installing between frameless cabinets, a ½” wide filler strip or side panel may
be needed on the hinge side. The filler strip will act as a spacer between the appliance case and adjacent
cabinet door swing. The width of the opening must include the filter panels.
Note:
The door should protrude at least 1” beyond the surrounding cabinets.
The clearance is : 2
”
14
23 1/4”
23 ½"
34”
24 1/2”
including handle
