AW5802xTP
User’s Manual
PAGE 10
Technical Support (650) 384-0000
www.avalanwireless.com
Advanced Admin Page Settings: On the Advanced Admin page, set the parameters as follows:
• Choose Device Type: Access Point or Subscriber Unit.
• For Subscriber Units, assign unique ID numbers in numeric order from 1 to 63.
• For an Access Point, enter the number of Subscriber Units that will be communicating with it.
• Click the box labeled “Enable User Specified Keys.”
• Choose an 8-digit hex (0-9 and A-F) Network Name that will be common among the AP and its
SUs and enter it. The hyphen is required.
• Choose a 32-digit hex encryption key and enter it. Again, the hyphens are required. This key
must also match among all the radios in the set so make a note of it as well.
After entering the parameters, click the “Apply” button to save them to the radio.
Linking All The Radios: When all of the radios are keyed and operating, connect them to your net-
work and Ethernet devices as desired and cycle the radio’s power to begin normal operation. Browser
management of the SUs can be performed over the wireless links. Note: avoid plugging actively linked
radios into the same Ethernet switch because this will corrupt the switch’s routing table and may
cause network problems just as if you had plugged a CAT5 cable directly between two ports.
