Avacen HOME XL, Руководство пользователя, Страница: 9 / 24

20220913
AVACEN HOME XL, AVACEN R3 HOME XL User Guide 5
10. OPERATING INSTRUCTIONS (NORMAL MODE OPERATION)
Connect the Power Supply Connector into the power supply jack. The
power supply jack is located on the right side panel towards the lower
back corner. Plug the AC power cord end from the power supply cord
into the correct power source (wall plug) - HOME XL-240V~, 50-60Hz.
International use: Care should be taken to ensure that you have the
correct cord and wall plug for the country in which the AVACEN R3
HOME XL is to be used. Contact AVACEN if the wall plug on the cord does not fit.
If the device has been stored in a hot or cold area, allow it to reach normal room temperature for
1 hour before turning it on.
Turn on the AVACEN device by inserting power plug. The display will show a welcome message.
Advancing beyond this welcome screen, you will see the Language selection. Please select the
desired language. After the language is selected, there will be disclaimer screens (only on first
power up)
. Please acknowledge that you meet the criteria by pressing “Yes” for these disclaimers.
Once completed, you will arrive at the “Please Wa it, Warming up ” screen. This message will
remain until the hand pad has reached 98.6° F.
When the hand pad reaches the predetermined standby
temperature, the home screen will be displayed. For best
results, t
he default temperature is “High , ” and the default
therapy time is 20 minutes. These values may be adjusted by
pressing the up and down arrows for the subsequent settings.
Once you have selected your desired settings for therapy and advance to the next screen, you
will see a message to remove all jewelry. This is to prevent damage to the Mitt and cuff
membrane. Please remove all jewelry (rings, bracelets, watches) from the hand and wrist that
will be used for therapy. If you are wearing a shirt or jacket
with long sleeves, pull the sleeve up your arm so that the
inflatable cuff contacts bare skin on your arm. The inflatable
cuff WILL NOT seal against a watch or shirt sleeve.
The next screen will prompt you to place the AVACEN mitt on the hand you
plan to use for therapy. Place therapy hand in the Mitt. All 4 fingers should
be placed in the body of the mitt and the thumb should be placed in the right
or left thumb cavity of the mitt.
Important - Leave 1 cm (1/2 inch) in top of
mitt free when placing hand inside, and ensure that the pressure holes are
facing up.
When ready, press the “Next” icon.