AV123 Onix Rocket ULW-10, Руководство по использованию

Страница: 7 / 17

Section 3—Connecting Your ULW-10 Subwoofer
When making your connections, be sure to use a high quality and reliable interconnect cable. It should
be shielded and long enough to do the job, but not excessively long. Your subwoofer cable is likely to
be the longest interconnect in your system.
The simplest connection between a home theater receiver or processor and your ULW-10 Subwoofer is
directly from the pre-amp output to the LFE input on the ULW-10. See figure 3.1.
If used with a 2-channel integrated amplifier, or any source without a dedicated sub/LFE output, you
will need to use a Y-splitter to join the L and R low-level output from your preamplifier or receiver.
Often,
Tape or Monitor outputs will provide an appropriate low-level stereo signal if the dedicated
output does not exist. Note: you may use the tape out as a last resort as the volume level is fixed and
you need to adjust the level control on the back of the subwoofer anytime you change the main
volume control.
See figure 3.2 below…
U
LW
-1
0
6.
NOTE: Please be sure your subwoofer is not plugged in and the rest of your system is turned off.
Figure 3.1
Figure 3.2
!
LFE Output
RCA Interconnect
LEVEL
0db
PRT
POWER
LFE
INPUT
MIN +15db
PHASE
0 180
LEVEL
0db
PRT
POWER
LFE
INPUT
MIN +15db
PHASE
0 180
Stereo pair RCA Interconnects
Stereo R and L Output
Splitter