P.16
User Guide
1-way remote
a.
Rapidly press AUX twice. While the remote’s LED is flashing, press and hold until the
parking lights flash for 2 seconds, pause, and then flash once.
To verify whether the system is in cold weather mode:
The
icon should appear on your remote display.
OR
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal
is pressed. (Automatic transmission ONLY)
Extended
Run
Time
While the vehicle is running remotely, press and hold the button until the remote beeps 3 times.
This will reset the run time counter to zero and restart the run time cycle from the beginning
Note: The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press and release the button.
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle has
been running for 2 minutes already, pressing the button will reset the counter to zero and allow
the engine to run for another cycle (in this case, 3 minutes).
Intrusion
Codes
via
LED
light
The system monitors the following:
•
Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
•
Doors
•
Ignition
•
Trunk
•
Hood
Note: If an intrusion has occurred, the siren will sound for a maximum of 60 seconds.
When an intrusion has occurred, pressing
will make the siren chirps four times. The antenna’s
LED will provide an intrusion code corresponding to the type of the intrusion that occurred. The
LED intrusion codes are flashed in continuous loops.
2x = Doors intrusion
5x = Panic
3x = Shock Sense
6x = Ignition
4x = Hood
7x = Trunk
Car
Finder™
When enabled, the Car Finder™ option will help you locate your vehicle by sounding a siren or the
horn. To initiate,
1.
Through advance function remote’s menu (page-6), select L-01.
2.
Press to sound the siren once without affecting the door.
Temperature
Request
(If
ACC
Temp
101
installed)
The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
101) is installed:
•
Through the remote’s advanced function menu (page-6), select L-01.
•
Immediately press the
button and hold it until the temperature is displayed on the
LCD screen.
