P.10
User Guide
2.
With the engine running, apply the parking
brake once and release the brake pedal.
3.
Within 20 sec. of engaging the parking
brake, press and hold
,
or on the
transmitter (SmartStart™ uses only the
SmartStart™ icon).
The parking lights will flash 3 times quickly
and remain lit. Release the button.
2.
With the engine running, apply the parking
brake twice within 10 sec.
3.
Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
4.
Remove the key: the engine will keep on running.
5.
Exit the vehicle. All doors should be closed, including the hood and trunk.
6.
THERE ARE THREE POSSIBLE OPTIONS TO COMPLETE READY MODE (programmable by installer)
OPTION 1: Automatic shut
down without auto lock
OPTION 2: Manual shut down
(default)
OPTION 3: Automatic shut
down with auto lock
The engine runs for 8 sec.
before finally shutting down
the engine, without user
interaction.
The engine keeps going until you
press either;
a.
to lock the doors and shut
down the engine;
b.
to unlock the doors and
shut down the engine;
c.
to shut down the engine
without affecting the doors.
The engine runs for 8 sec.
then locks the doors before
finally shutting down the
engine, without user
interaction.
WARNING: The vehicle is
not armed or locked down.
WARNING: Engine runs until the
pre-programmed run time
expires.
WARNING: Do not leave
your keys in the vehicle!
7.
The Parking lights will flash twice and the
icon will appear on screen to indicate Ready
mode is set. If the icon doesn’t appear, refresh the screen by pressing
.
Remote
Starting
1.
Press the button for approximately 1 second and release.
2.
The remote will beep once and the LCD will display “START”.
3.
The remote will confirm the remote starter’s activation by beeping 3 times.
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving
Off
With the vehicle running remotely, press the
button to disarm the system and the starter kill (if
installed) and unlock the doors. Enter the vehicle and do the following:
1.
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the “Takeover mode” can be
set for your vehicle.
