User Guide
P. 7
x
To access a feature that is programmed as level 1, press the
SHIFT
button once followed by the
desired function.
x
To access a feature that is programmed as level 2, press the
SHIFT
button twice followed by the
desired function.
x
To access a feature that is programmed as level 3, press the
SHIFT
button three times followed
by the desired function.
Your installer can customize the system as to personalize these multi-level features in an order that
best suits you. Your options are:
Option 1:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Multi-car operation
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Basic
features
Level 3
(requires pressing the
SHIFT
button 3X)
Æ
Customized
features
Option 2:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Basic
features
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Multi-car
operation
Level 3
(requires pressing the
SHIFT
button 3X)
Æ
Customized
features
Option 3:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Customized features
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Multi-car
operation
Level 3
(requires pressing the
SHIFT
button 3X)
Æ
Basic features
Option 4:
Level 1
(requires pressing the
SHIFT
button 1X)
Æ
Basic features
Level 2
(requires pressing the
SHIFT
button 2X)
Æ
Customized
features
Level 3 (
requires pressing the
SHIFT
button 3X)
Æ
Multi-car
operation
Example:
If the multi-level features were set to option 3, the setup would be as follows:
x
Level 1
Æ
Customized feature
x
Level 2
Æ
Multi car operation
x
Level 3
Æ
Basic
features
The
“Basic features”
are now programmed as level 3 and therefore:
x
To access the
aux.2
feature, the user needs to press on the
SHIFT
button
three
(3) times
followed by the
LOCK
button.
x
To access the
status request
feature, the user needs to press on the
SHIFT
button
three
(3)
times followed by the
TRUNK
button.
x
To access
cold weather mode
, the user needs to press on the
SHIFT
button
three
(3) times
followed by the
START/STOP
button.
Note:
When using the companion remote, Shift button must be pressed twice quickly the first time.
For instance, to access
customized feature 1
,
press
SHIFT
twice quickly,
SHIFT
and
SHIFT
again
followed by Lock.
Remote-Starting Your Vehicle
Press the
START/STOP
button for approx. 1 second. The parking lights will come
ON
and the
transmitter will beep once to inform you that the remote starter has received your signal.
Approximately 5 seconds later, the engine will start. The transmitter will beep 3 times and the
parking lights will remain
ON
during the pre-programmed run time of the engine.
If the vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
