The Parking Lights will stay on for up to 20 seconds
.
2.
Turn the Ignition Key to the
IGNITION ON (RUN)
position.
Wait until the Parking Lights go out, then turn the Ignition Key
OFF
,
ON
then back
OFF
again.
The L.E.D. will be flashing during the next step.
3. Press
the
TRUNK
button, wait 1 sec. and press the button again until the Parking Lights flash 5 times quickly and
the Siren chirps
twice
.
You can alternatively press the button repeatedly until you see 5 flashes and hear 2 chirps.
4.
To exit, close the Hood.
VI. Resetting the Module
The AS-6105 SH/SR is equipped with a reset function that allows the installer to erase all Transmitter codes from
memory and return all the Programming Options to the factory default values.
To reset the Module:
1.
Ensure that the system is not in Valet Mode, that the Hood is up and that the Ignition is
OFF
.
•
Hold the Hood Pin-switch down for 4 sec.
•
Release the Pin-switch.
The Parking Lights will come on.
•
While the Parking Lights are on, immediately push and release the Pin-switch again.
The Parking Lights will stay on for up to 20 seconds
.
2.
Press the Valet Button 6 times (
down-up / down-up / down-up / down-up / down-up / down-up
) or more, until
the Parking Lights start to flash
.
The Parking Lights will flash 8 times.
Note
After reset, all Programming Options are set back to de-
fault. See the programming page for default values.
VII. Events Logging
With this feature, the Module will play back the last 4 Start Failure Events Codes and the last Intrusion Code via the
Parking Lights or L.E.D.
Events playback
Ensure that the Hood is up and that the Ignition is
OFF
.
•
Hold down the Hood Pin-switch for 4 seconds.
•
Release the Pin-switch.
The Parking Lights will come on.
•
With the Parking Lights on, immediately push the Pin-switch 3 times (
down-up / down-up / down-up
).
The Parking Lights and L.E.D. will flash the five events stored in memory.
The first four playback codes are
Start Failure Events
, while the last playback code is an
Intrusion Code
. There is a
pause after each event code is played back.
The system will play back the most recent event first, then the second one, and so on. If there is no event at all to
report, the Parking Lights will give one long flash.
To jump directly the Intrusion Code, press the Brake Pedal. To end playback close the Hood.
Intrusion Codes
Start Failure Codes via Parking Lights
1 x = No Start
1 x = Power-up Reset: Battery disconnected / reconnected or
dead…
3 x = Hardware Reset
4 x = Brakes
2 x = Doors intrusion
5 x = No Tach Cut-off
3 x = Shock Sense
6 x = Hood
4 x = Hood
7 x = Engine Running, no Ignition detected, or
Tach before Start
5 x = Panic
6 x = Ignition
8 x = Tach signal detected without Ignition;
contact Autostart for assistance
Note
: “
x
” stands for one flash of the Parking Lights
9 x = Reserved for testing purposes
10 x = Alarm condition
P. 4
Quick Installation Guide
AS-6105 SH/SR
