The Programming Assistance Button
(A.k.a. the
PAB
.) Mounted on the Remote Car
Starter, this button can be used from within the
vehicle instead of the Hood Pin switch in the
Engine compartment. This will spare the
installer the trouble of accessing the Hood Pin
switch in the Engine compartment.
Caution
The Hood Pin switch must be installed and con-
nected in order for the Programming Assistance
Button to function.
The button will work only
when the Hood is up.
Programming a Transmitter
Before you Proceed
The Transmitter of the Remote Car Starter is not delivered pre-programmed: it must be
programmed after the wiring of the Remote Car Starter is completed. The Remote Car
Starter has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be lost from memory.
To erase all
Transmitter codes from memory, you must perform a reset of the Remote Car Starter
(see
Resetting the Remote Car Starter
, later in this Guide, for more details).
The Transmitter Programming procedure
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the
IGNITION ON (RUN)
position.
– Immediately turn the Ignition Key back to the
OFF
position.
– Press and hold the
LOCK
button and keep it down until the Parking Lights flash
5 times quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
2. To exit: close the Hood.
Table 2: Programming a Transmitter
To program a Transmitter
on the second vehicle for Multi-car Operation, you must press
the
TRUNK
and
LOCK
buttons simultaneously (instead of
LOCK
or
UNLOCK
) in transmitter
programming procedure.
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the
installer to custom-fit the system outputs according to installation requirements. The
Programming Options are designed to facilitate interfacing with all vehicle types. (See
section
Table of Programming Options
later in this Guide.)
P. 10
Installation Guide
AS-2510 TW