AS-1785
Installation Guide
P. 13
memory, you must perform a reset of the Remote Car Starter
(see
Resetting the Remote Car
Starter
, later in this Guide, for more details).
The Transmitter Programming Procedure
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the
IGNITION ON (RUN)
position.
– Immediately turn the Ignition Key back to the
OFF
position.
2.
Press and hold the
LOCK
button and keep it down until the
Parking Lights flash
5 times
quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
3.
To exit: close the Hood.
Table 2: Programming a Transmitter
To program a Transmitter
on the second vehicle for Multi-car Operation, you must press the
TRUNK
and
LOCK
buttons simultaneously (instead of
LOCK
or
UNLOCK
) in step 3 of the Transmitter
code-learning procedure:
Entering Programming Options Mode
The Remote Car Starter is equipped with three custom programming Modes that allow the installer
to custom-fit the system outputs according to installation requirements. The Programming Options
are designed to facilitate interfacing with all vehicle types. (See section
Table of Programming
Options
later in this Guide.)
1.
Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay
ON
for up to 20 seconds.
– Before the lights go out:
2.
Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
•
LOCK
..................to access Mode 1;
•
UNLOCK
..............to access Mode 2;
•
TRUNK
................to access Mode 3.
The
Parking Lights
will
flash
and the
Horn
will
honk
once, twice or three times to
confirm entry into a Mode.
3.
Release the Brake Pedal.
Table 3: Accessing modes
Note
The Unit will stay in the selected programming Mode until the Hood Pin-switch or the Brake Pedal
is pressed again.
Therefore take your time to make the proper selection.
Pressing the Brake
Pedal will take you back to the Programming Centre, where you can select a different Mode.
Once you access a particular programming Mode, you will automatically start at Function 1. Once
you select one of the Options of Function 1, you will automatically be taken to the next Function.
To select one of the four Options
of any given Function, press the corresponding button on the
Transmitter:
•
LOCK
button .........................to access Option 1
•
UNLOCK
button .....................to access Option 2
•
TRUNK
button .......................to access Option 3
•
START
button .......................to access Option 4
