AS-1725 SH
Guide d’installation
P. 3
Using the Remote Control
Your Remote Car Starter is equipped with a 5-button multi-channel remote control. It can operate
two independent vehicles equipped with a Remote Car Starter (see
Multi-Car Operation
section,
later in this Guide, for second-car transmitter functions).
The functions of the transmitter are as follows:
Pressing the
LOCK
and
UNLOCK
buttons simultaneously will activate the
AUX 2
output.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on
HIGH
. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Arming the Starter Kill
The Starter Kill (if installed) can be configured by the installer so as to arm automatically (Passive
Mode) or not to arm automatically (Active Mode). See section
Passive or active arming
, later in
this guide, for more details on Passive Mode and Active Mode.
•
To
disarm
the Starter Kill, press the
UNLOCK
button on the transmitter.
The parking lights will flash twice.
If remote door locks are installed, this will also unlock the doors.
•
To
arm
the Starter Kill, press the
LOCK
button on the transmitter.
The parking lights will flash once.
If remote door locks are installed, this will also lock the doors.
•
In
Passive Mode
, the Starter Kill will automatically arm if the ignition key is not inserted
Into the ignition switch within 1 or 3 minutes after unlocking (the key sense feature
must be installed).
