P.8
User Guide
4.
Press the
button to lock the doors and to arm the starter kill (if available). The engine
will continue running.
a.
When re-entering the vehicle, the user must reinsert the key into the ignition and turn it
to the
ON
position (not Crank) without pressing on the brake.
b.
Once the key is in the ON position
, press on the brake pedal to put the transmission in
gear. Pressing the brake pedal at this step will cancel the remote starter takeover.
c.
Drive off.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for
Ready Mode
(page 4)
; at the last step, press the
&
buttons together to
lock the doors and leave the engine running.
Valet Mode
When the vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine from being
remote-started accidentally.
Ignition Valet:
This feature allows you to set Valet Mode using the ignition key.
To put the system into Valet Mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN
and
OFF
positions 5 times until the parking lights flash
3 times
.
2.
Turn the ignition
OFF
.
3.
The LED on the antenna will stay
ON
indicating that the vehicle has successfully entered
Valet mode.
To take the system out of Valet Mode using the KEY (Ignition Valet Mode):
1.
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN
and
OFF
positions 5 times until the parking lights flash
2 times
.
2.
Turn the ignition
OFF
.
3.
The LED on the antenna will switch
OFF
indicating that the vehicle is now out of Valet mode.
If someone attempted to remote-start the vehicle while in Valet Mode; the parking lights will turn
ON
, then
OFF
, then will flash
twice
.
Cold Weather Mode
If the vehicle has a manual transmission,
Ready mode
(page 4)
should be set before entering
Cold Weather mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs
for 3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends
after 24 hours (or 12 starts).
To enter Cold Weather Mode:
Press and hold the
button for at least 3 seconds
The parking lights will flash for 2 seconds, pause, then
flash 3 times.
OR
If
was programmed as
LOCK
&
UNLOCK
by your installer, press and hold the
button for at least 3 seconds until the parking lights will flash for 2 seconds, pause,
and then flash 3 times.
