P.6
User Guide
Driving Off
With the vehicle running remotely, press the
button (ONLY if programmed as the
LOCK
or
UNLOCK
button) to disarm the starter kill (if installed) and unlock the doors. Enter the vehicle and
do the following:
1.
Turn the ignition key to the
IGNITION ON (RUN)
position. (Do not turn the key
to the
CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note:
On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the “Takeover mode” can be
set for your vehicle.
Arming and disarming the starter kill (if installed)
This added security feature will prevent the vehicle from starting with the Ignition key when the
starter kill is armed. If the system was installed with the starter kill option, the vehicle will not be
able to start with the key unless the system has been unlocked first or put into Valet Mode
(page 8).
Note:
If the Starter Kill is installed, the vehicle will benefit from a protection against starter motor
damage that could occur after remote-starting the engine should the user, by force of habit, turn
the ignition key to the
CRANK
position.
The Starter Kill (if installed) can be configured by the installer either to
Passive Mode
(so as to arm
automatically) or
Active Mode
(so as to require the user’s intervention for arming). By default, the
Remote Car Starter is configured to
Passive Mode
.
Note:
This feature is only available if the
button is configured as
LOCK
or
UNLOCK
.
Passive mode:
To
arm
the Starter Kill:
Press the
button on the transmitter.
OR
Let the Starter Kill arm automatically 1 minute (by default) or 3 minutes (if configured this way)
after the ignition is turned
OFF
or once the last door is closed (if the doors are monitored).
The LED on the antenna will remain OFF during the countdown preceding the activation
of the Starter Kill.
Once the activation countdown expires, the LED will flash slowly to indicate that the
Starter Kill is now armed.
To
disarm
the Starter Kill:
Press the
button on the transmitter.
The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if
configured this way) if no door is left opened (if the doors are monitored) and the ignition
is
not
turned
ON
.
