Autoquip SRP, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 40

INSTALLATION INSTRUCTIONS
FLOOR INSTALLATION
1. Make sure floor is clean and level before starting.
2. Place the turntable in the installation area.
3. If the permanent electrical work is not complete, some means of temporary lines with
an on-off device for the power supply should be set up for testing purposes.
15
CAUTION!
When lifting the turntable, do not attempt to pick it up by the
platform; it is attached in the center only and could be damaged.
Pick up the turntable from under the base frame ONLY using a
strap sling.
4. Make temporary electrical connections. Operate the turntable to ensure that rotation
is in the proper direction.
5. If needed, shim to the desired height. DO NOT “spot” shim. Shim the full length of
the base frame. This will prevent the plate from bending under an exceptionally
heavy load.
DANGER!
HIGH VOLTAGE!! – Disconnect and/or lock out the electrical
supply to the power unit per OSHA regulations prior to any
installation or maintenance being performed.
6. The base plate of the turntable has pre-drilled holes for lagging it securely to the
floor. Mark the holes, drill, and install with anchors. Turntables with oversize
platforms have minimum pull out requirements of 2,000 lbs. for each anchor.
7. Make permanent electrical connections and operate the turntable through a few
cycles.