4
If entered digit is not correct, enter the code once more in that case. Several codes
can be entered without exit of setup mode.
Turn the ignition off to exit setup mode. New settings are saved in nonvolatile
memory of the module and stored there regardless of whether the module is
connected or not to the car.
Note:
If you start the engine during Setup mode, new
settings will not be saved in memory.
To reset the module to the factory settings, enter the code 8.1.1. The LED should
flash three times, confirming command execution. Then the module exits Setup
mode and restarts.
Settings Table (3)
Settings
Group
Settings
Item
Possible Values
1.
Heater
operation
time
1.1.
Limitation of
heater total
operational time in
pre-heat mode
1.1.1
*Not adjusted
1.1.2
40 minutes
1.1.3
50 minutes
1.1.4
60 minutes
1.1.5
70 minutes
1.1.6
80 minutes
1.1.7
90 minutes
1.1.8
100 minutes
1.1.9
120 minutes
1.2.
Limitation of
heater 1-cycle
operational time in
pre-heat mode
1.2.1
10 minutes
1.2.2
15 minutes
1.2.3
20 minutes
1.2.4
25 minutes
1.2.5
30 minutes
1.2.6
40 minutes
1.2.7
50 minutes
1.2.8 *
Not used
2.1.
“Lock” and
“Unlock” buttons
functions for heater
control
2.1.1
*”Lock” button for heater start,
“Unlock” button for heater stop
2.1.2
“Unlock” button for heater start,
“Lock” button for heater stop
2.2.
Number of
sequential “Unlock”
button presses for
heater control
2.2.1
Combination disabled
2.2.2 *
Two presses
2.2.3
Three presses
2.2.4
Four presses
2.3.
Number of
sequential “Lock”
button presses for
heater control
2.3.1
Combination disabled
2.3.2 *
Two presses
2.3.3
Three presses
2.3.4
Four presses
3.
Battery
3.1.
Minimal battery
3.1.1
* Not adjusted
3.1.2
11.7V
