3
Basic Functions
1.
To start the heater by using car’s remote control key press “Lock” button 3
times. Time intervals between presses must not exceed 20 seconds. The
excess of time interval restarts the counter of “Lock” button presses. Car
confirms commands reception with hazard signals flashing.
2.
To stop the heater by using car’s remote control key press “Unlock” button 3
times. Time intervals between presses must not exceed 20 seconds. The
excess of time interval restarts the counter of “Unlock” button presses. Car
confirms commands’ reception with hazard signals flashing.
3.
It is possible remotely disable startups of the heater, programmed in the CIP.
Use remote control key to send stop command when the heater is idle.
Starting the heater any way or turning the ignition to “on” position enables
CIP timers again.
4.
Additionally installed button can be connected to the module. The button is
used for immediate start and stop of the heater. Button pressing changes
heater condition to another one: switches off operated heater or switches on
idle heater.
5.
If additional remote control connected to the RCP, its functionality depends
on connection schemes, module settings and the remote control possibilities.
See remote control documentation for details.
Additional Functions
By default RCP adjusted to perform only basic functions, such as start and
stop of the heater from the remote control key. To turn on the additional functions
such as battery monitoring, flashing with direction indicators in rearview mirrors,
etc. enter the module into Setup mode and activate corresponding setup item (see
settings table 3).
Programming button and the brake pedal are used to enter Setup mode and
to the settings change. Use additionally installed button as programming button.
It is necessary to stop the engine and the heater before. Turn the ignition on
by holding engine start button for 2 seconds at least, then press and hold the brakes
pedal. Press the programming button for 3 times (each time hold the button until
LED goes off, about 1.5 seconds). The LED will go on confirming the Setup mode
entering. Release the brakes pedal.
Each setup item in the settings table is a 3-digit code. To enter a digit of a
code, shortly press the programming button so many times, as corresponds to a
digit. The LED confirms each button press by going off briefly. To complete a
digit entering, press and release brakes pedal. The module confirms it with one
brief flash of the LED. When all three digits entered, the module checks the code
for validity and confirms valid code with double LED flashing.
