Autoplugin Key-V4, Руководство пользователя

Страница: 4 / 8

4
Basic Functions
1. A special combination of buttons presses is used to start the heater with the
remote control key. Firstly press “Lamp” button on the key to switch on the
car’s lighting. Then press “Lock” button twice within 30 seconds, while
lighting is on. Every “Lock” button pressing is confirmed with direction
indicators flashing.
2. To stop the heater with the remote control key, switch on and then switch off
car’s lighting twice. Intervals between “Lamp” button presses should not
exceed 20 seconds.
3. It is possible remotely disable startups of the heater, programmed in the CIP.
Use remote control key to send stop command when the heater is idle.
Starting the heater any way or turning the ignition to “on” position enables
CIP timers again.
Additional Functions
By default the module adjusted to perform only basic functions, such as start
and stop of the heater using the remote control key. To turn on the additional
functions such as battery monitoring, flashing with direction indicators in rearview
mirrors, etc. enter the module into Setup mode and activate corresponding setup
item (see settings table 1).
The buttons of the left-hand stalk switch and the brakes pedal are used to
enter Setup mode and to change the settings. It is necessary to stop the engine and
the heater before. Turn the ignition on by holding engine start button for at least 2
seconds, then press and hold the brakes pedal. Further press and hold for at least 5
seconds “Read/OK” button while module’s LED flashes once a second. Both
direction indicators in the CIP confirm entering the Setup mode with 2 flashes.
Release the brakes pedal and “Read/OK” button finally.
Each setup item in the settings table is a 3-digit code. To enter a digit of a
code, shortly press “RESET” button so much times, as corresponds to a digit. The
LED and the direction indicators symbols in the CIP confirm each button press: the
LED briefly goes off, the left direction indicator flashes one time when the first or
the third digit of code is entered, the right direction indicator - when the second
digit of code is entered. To complete a digit entering, press and release “Read/OK”
button. The CIP confirms it with one flash of both direction indicators
simultaneously. When all three digits entered, the module checks the code for
validity and confirms it with the direction indicators flashing. The both direction
indicators flash twice simultaneously in case of valid code and flash twice
alternately in case of invalid code.
If entered digit is not correct, press and release “Read/OK” button until the module
indicates an error. Enter the code once more in that case. Several codes can be
entered without exit of setup mode.