Q & A
How can I tell if the photocell is working?
There is a built-in 20
second time delay for the photocell to change status. A green
LED on the top RIGHT edge of the unit that says “Daytime” will
light up when the photocell is in Daytime mode.
Can I connect more than one device to the unit.
Yes…
As long
as the total amperage of the devices connected to the unit do not
exceed the maximum rating of the unit. We recommend the total
amps not to exceed 75% of the rating.
The temperature of the area does not seem to be correct?
The sensor is located on the bottom on the unit in the protective
plastic “cage”. Ensure the unit is not being affected by other
factors such as direct sunlight exposure or areas that may not
have good air movement.
What if there is no power?
Ensure the unit is getting power.
Check the device that is connected to the unit by plugging it
directly into a known power supply. If the unit will not turn on and
no LEDs will illuminate, contact your distributor for repair and
warranty issues.
Why are the red and yellow LED lights blinking and no
power
? The blinking lights tell user the unit is in over current
protection mode. It may be caused by large load current. Please
unplug the unit and plug in again to resume the normal operation.
If the user does not re-plug the unit, it will attempt to re-power
itself after 10 minutes. After the error is reset, the unit will resume
the normal operation.
Made in China