6/18/2007
RS-602 REV A.
7
To:
White/Black
Wire /
Negative safety
To Vehicle Brake Switch
Hood Pin Switch
Diode
H3/4
BLACK/WHITE
WIRE
(-)Neutral Safety Switch Input
(-)Remote Start Enable Toggle Switch Input
When the BLACK/WHITE wire is grounded, the remote start unit is operable. When this wire is open from ground, the
remote start is disabled. This wire must be connected to the vehicles Neutral safety switch!
1. The optional “remote start toggle switch” can be added on to temporarily disable the Remote Start Device, it can
prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or
stored in an enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF
position. To enable the remote start, move the optional remote start enable toggle switch to the ON position.
2. This wire MUST be connected to the PARK/NEUTRAL switch in the vehicle. (See the TESTING YOUR
INSTALLATION GUIDE)
IMPORTANT NOTE: Directly connect the BLACK/WHITE wire to the “GROUND” when this wire is not used.
H3/5. WHITE/VIOLET WIRE
: Positive safety shut down input
This wire provides an instant shutdown for the remote start, whenever it gets +12volts. If the brake lights switch in the
vehicle sw12 volts to the brake light circuit, connect this wire to the output side of the brake switch. This will allow
the remote start to shut down if an attempt is made to operate the vehicle without the key while running under the control
of the remote start. In most vehicles, in order to shift gear, the brake pedal must be depressed. The brake input will in turn
cause the remote start unit to shut off. See below diagram.
+12 volts from fuse box
To White/ Violet
wire
Brake light bulbs
Switch closes when
brake is depress
H3/6. GRAY WIRE
: (-)200mA Chaneel #3 output -
This will become a 1 second pulse ground by activate channel 3 on transmitter for two seconds, the current capacity
of this wire is 200 mA. This feature allows you to remote control trunk release or other electric device.
H3/7. WHITE WIRE:
(-) 200 mA Ground output while the engine is starting or running. This wire can be used
to activate a by-pass module and will provide a ground output when the engine is starting or running
from the remote starter.
H3/8 PINK WIRE
: (-) 200ma PROGRAMMABLE OUTPUT
(See Alarm Feature
I - 2
Programming)
FACTORY SECURITY DISARM SIGNAL OUTPUT
–(Factory Default Setting) --
This wire is designed to disarm a factory installed security system. This wire sends a negative (-) 1 second pulse
upon a remote start and remote door unlocking. Some factory systems must be disarmed to allow remote starting. In
most cases, this wire may be connected directly to the factory alarm disarm wire. The correct wire will show nagative
ground when the key is used to unlock the doors or trunk. This wire is usually found in the kick panel area in the
wiring harness coming into the car body from the door.
START STATUS (Shock Sensor Bypass Control) OUTPUT–
