Autopage C3-RS-665, Руководство по установке

Страница: 11 / 34

11
wire to terminal #87a of the relay. Connect the other side of the (#1)
wire to terminal #30.
5. Connect the previously selected resistor from terminal #87 to the
second (#2) wire (as shown).
To + 12 V
Ignition
Switch
YELLOW wire
Matching Resistor
VATS control Module
87a 86
30
87
85
VAT wire (#1)
VAT wire
(#2)
WHITE WIRE – (-) 200ma PROGRAMMING OUTPUT
(See Alarm Feature A - 6 Programming)
DOME LIGHT CONTROL OUTPUT (Factory Default Setting) —
This wire becomes grounded when the dome light control circuit is
active. The current capacity of this wire is 200mA. This wire can control
the operation of the interior lights. An optional 10 Amps relay can be
added to this system for interior lights operation.
a). Upon disarming, the interior lights will remain on for 30 seconds.
b). If the vehicle is violated, the interior light will flash for the
same duration as the siren.
87a
86
87
30
85
Fuse
White Wire
+12V
Domelight
Door
Switch
Courtesy
Light
FACTORY SECURITY REARM SIGNAL OUTPUT–
(See Alarm Feature A- 6 Programming)
This wire is designed to rearm a factory installed security system. This
wire will supply a pulse whenever the remote start times out or is shut
down using the transmitter and remote door locking.
HORN OUTPUT, (-) 200mA output
(See Alarm Feature A- 6 Programming)
This provides a negative output to be connected to the vehicles
negative horn trigger. This is a transistor output and should be
connected before the factory horn relay.