Autonics AAiSA-86LA, Руководство пользователя

Страница: 28 / 62

4 Installation
28 © Copyright Reserved Autonics Co., Ltd.
4.2.3 Connection with Load
When connecting the load, be sure of alignment of the center, tension of the belt, and
parallel of the pulley.
When connecting the load such as a pulley or a belt, be cautious of the allowable thrust
load, radial load, and shock, as well as tighten the screw for a coupling or a pulley not to be
unscrewed.
When attach a coupling or a pulley to the shaft, be cautious of damage on shaft or bearings
and it is banned to disassemble or change structure of the device or the shaft for connecting
with a load.
4.2.3.1 Direct Load Connection with Coupling
※ Use Autonics flexible coupling (ERB Series)
When connecting a load such as Ball screw or Tm screw directly to the shaft of the motor,
use flexible coupling as image showing above.
If the center of the load and the shaft is not aligned, it may cause severe vibration, damage
on shaft or shortened life cycle of bearings.
4.2.3.2 Load Connection with Pulley, Belt, and Wire
The motor shaft and the load shaft should be parallel. Connect the motor shaft and the line
which connects the center of two pulleys to a right angle.
4.2.3.3 Load Connection with Gear
The motor shaft and the load shaft should be parallel. Connect the motor shaft to the center
of gear teeth side to be interlocked.