ADS-RR(SR)-HK1-DS-IG-EN
maestro.idatalink.com
Hyundai elantra Gt witHout amP witHout naV 2014-2015
Automotive Data Solutions Inc. © 2021
6
TROUBLESHOOTING TABLE
PROBLEM
SOLUTION
Gauges do not work, radio shows OBD2 Error 1 or Error 2.
Refer to STEP 3 in the wiring diagram.
Ensure OBDII connector is securely attached to the OBDII connector of the
vehicle (if applicable).
or
Ensure the
RED/ BROWN
wire of the HK1 harness and the
YELLOW/
BROWN
wire of the HK1 harness are connected as shown.
Do not use T-Taps. Soldering or military splicing methods are recommended.
If anything else is connected to the OBD2 or CAN wires of vehicle
(programmer, throttle controller, insurance tracker, etc.) try unplugging it to
see if gauges work. If gauges work without it installed, call tech support for
options.
Reset the RR.
The light on the Maestro is blinking
RED TWICE
and the radio IS turning on.
Ensure the 4-pin data cable is connected between the radio and the RR, and
that it is plugged into the black port on the Maestro RR. The red and blue
ports on the RR should be empty.
Make sure the correct radio model and serial number were entered during
the fl ash. Verify the radio’s serial number entered during the fl ash matches
what is listed on the radio screen. This can be found in the settings of the
radio, listed as Device Id, Device Number, or Serial Number.
The light on the Maestro is blinking RED TWICE but radio is NOT turning on.
If installing a fl oating screen type radio and it is not turning on, ensure the
screen is secured and any trim pieces on the radio have been installed fully.
Not installing these fully will prevent radio from powering up and show a 2x
red error as well.
The light on the Maestro is fl ashing
RED ONCE
.
There is no fi rmware on the module; fl ash the RR module.
MAESTRO RR RESET PROCEDURE:
Turn the key to the OFF position, then disconnect all connectors from the module.
Press and hold the module’s programming button and connect all the connectors back to the module. Wait, the module’s LED will fl ash RED rapidly (this may
take up to 10 seconds).
Release the programming button. Wait, the LED will turn solid GREEN for 2 seconds to show the reset was successful.
TECHNICAL ASSISTANCE
Phone: 1-866-427-2999
Email: [email protected]
Web: maestro.idatalink.com/support add www.12voltdata.com/forum/
IMPORTANT: To ensure proper operation, the aftermarket radio needs to have the latest fi rmware from the manufacturer. Please visit the radio
manufacturer’s website and look for any updates pertaining to your radio.