2
Tech Support 770-844-4200
www.productivity2000.com
Power Supply Installation Procedure
Step One:
Locate the left most
socket in the base.
Step Two:
Insert the Power
Supply at a 45° angle
into the notch located
at the bottom of the
base and rotate up
until seated in socket.
Locked
Step Three:
Snap the retaining tab
into the locked position.
AC(L)
AC(N)
GND
LOGIC
GND
P2-01AC
Power Hookup
Grounding
A good common ground reference (earth ground) is essential for
proper operation of the Productivity2000 system. One side of all
control circuits, power circuits and the ground lead must be properly
connected to earth ground by either installing a ground rod in close
proximity to the enclosure or by connecting to the incoming power
system ground. There must be a single-point ground (i.e. copper bus
bar) for all devices in the enclosure that require an earth ground.