Automation Technology MCS 1280 Series, Руководство пользователя

Страница: 86 / 93

84 MCS Manual Rev. 1.4
Quickstart a Compact Sensor
This chapter explains the handling to set up a sensor and the computer to acquire the first images.
Set both computer and sensor to the recommended settings in the following.
1. Turn off all possible software which can block sent packages from the sensor to the PC
or the other way around like Firewalls or Antivirus software.
2. Connect the sensor directly or over a switch to the PC. Identify which network interface
card (NIC) is linked to the sensor.
3. Disable not needed filter drivers and protocols of the NIC port.
4. Set the computer Internet Protocol Version 4 (TCP/IPv4) to a fix IP address and a fix
subnet mask as well as the sensor. For example: PC: 169.254.64.1/255.255.0.0; Sensor:
169.254.64.2/255.255.0.0.
5. Enable Jumbo Frames if possible.
6. Starting the cxExplorer leads to the Device Selection. Chose the camera over the
available Transport Layer and open the device. If the camera isn´t visible check the IP
address or search for subnets.
By default the sensor starts in the factory mode. For the compact sensor the factory mode is either
the COG or the FIR Peak mode. Start the continuous image grab over or do a snapshot over
.
The first images were acquired.