Automation Direct T1K-DEVNETS, Руководство пользователя

Страница: 21 / 64

Installing the DeviceNet
Base Controller
Installation and
Safety Guidelines
2–8
Installing the T1K–DEVNETS Base Controller
Configuring the Controller
Use the software of your DeviceNet master to configure the controller for your
network.
Refer to the software Help file and/or manual for help with configuration.
Follow these basic steps when configuring your T1K–DEVNETS controller.
1. Set the Controller Node Address:
In the DeviceNet master software, make sure the Controller node address
is set to an available node number on the DeviceNet network (from 0 to 63).
2. Add the EDS file (if required by the software):
In your DeviceNet software, add the T1K–DEVNETS Electronic Data
Sheet (EDS) file from the disk which came with this manual or from our web
site
www.automationdirect.com . Some software may not provide for the
use of EDS files.
3. Commission the Node:
Use the DeviceNet software to “Commission the Node” of your Controller.
Again, some software may not require this.
4. Add the T1K–DEVNETS to the Scan List:
Add the T1K–DEVNETS to the Scan List in your DeviceNet Master
software.
5. Set the Input/Output Bytes:
If required by your DeviceNet software, set the I/O Parameters to Tx =
Output bytes and Rx = Input bytes (on the Scanner’s Scan List tab), for
Polled I/O.
Either use the tables located in the appendixes or go to page
E–18 and follow the steps in the example.
6. Map the I/O to the Master:
Map the T1K–DEVNETS I/O to the Scanner using Auto Map, or map the I/O
to another location if desired.
7. Scan:
Go Online (or Scan) to verify the configuration and check for errors.
8. View Indicators on the Controller:
Refer to the Status Indicators when connecting to the network.
Configuring the
DeviceNet Base
Controller