SR35 Quick-Start Guide
Stellar® SR35 Series Soft Starter Quick Start Guide – 1st Ed – 07/09/2020
3
Safety
I
mporTanT
InformaTIon
Installers should read and understand the instructions in this guide prior to
installing, operating and maintaining the soft start. The following symbols may
appear in this guide or on the soft start to warn of potential hazards or to draw
attention to certain information.
C
auTIon
s
TaTemenTs
The examples and diagrams in this manual are included solely for illustrative
purposes. The information contained in this manual is subject to change at any time
and without prior notice. In no event will responsibility or liability be accepted for
direct, indirect or consequential damages resulting from the use or application of
this equipment.
D
angerous
V
oltage
I
nDIcates
the
presence
of
a
hazarDous
Voltage
whIch
coulD
result
In
personal
Injury
or
Death
.
w
arnIng
/c
autIon
I
nDIcates
a
potentIal
hazarD
. a
ny
InstructIons
that
follow
thIs
symbol
shoulD
be
obeyeD
to
aVoID
possIble
Damage
to
the
equIpment
,
anD
personal
Injury
or
Death
.
Protective Earth (Ground)
Indicates a terminal which is intended for connection to an external conductor for
protection against electric shock in case of a fault.
1L1
3L2
5L3
2T1
4T2
6T3
M
3 ~
• SR35 soft starters contain dangerous
voltages when connected to the mains
supply Only qualified personnel that have
been completely trained and authorized,
should carry out installation, operation and
maintenance of this equipment
• Installation of the soft start must be made in
accordance with existing local and national
electrical codes and regulations and have a
minimum protection rating
• It is the responsibility of the installer to
provide suitable grounding and branch
circuit protection in accordance with local
electrical safety codes
• This soft starter contains no serviceable or
re-usable parts
• The STOP function of the soft starter does
not isolate dangerous voltages from the
output of the soft start An approved
electrical isolation device must be used
to disconnect the soft start from the
incoming supply before accessing electrical
connections
