SETTING LIMITS
13
8. SETTING DOOR TRAVEL LIMIT
POSITIONS VIA THE REMOTE CONTROL
IMPORTANT NOTE: The O/S/C button will not function
until the open and close limits position are set.
NOTE:
The opener is factory preset for installation on the
RIGHT HAND SIDE
. When the opener is mounted on the left
side of the door the opener will travel in reverse. To change the
direction of travel for
LEFT HAND SIDE
installation do the
following:
NOTE: Remove the control panel cover for access.
Remember to replace the cover when set up is complete.
1. Make sure the opener is engaged and power is connected.
2. Press the Close button briefly. The door should start to close.
3. If the door opens - release and press the OSC button within
2 seconds.
4. Press the Close button again to confirm that the door is
moving in the correct direction.
8.1 SETTING LIMITS
To code transmitter for setting limits
1.
Press and hold the Door Code button (
Fig. 14
).
2.
Press button 1 (
Fig. 15
) on the transmitter for two seconds.
Release and pause for two seconds. Press the same button
again on the transmitter for two seconds.
3.
Release the Door Code button.
To set limits
4.
With the opener in manual mode (
Fig. 12
) move the door up
by hand to an approximately mid open position.
5.
Re-engage the opener.
6.
Press button 4, the door will start closing, release the button
once you are 1 to 2 cm from your desired closed limit
position.
7.
Press button 4 briefly, each press will enable you to inch the
door to your desired closed position. (Press button 1 to adjust
position if necessary).
8.
Once you are happy with the position press button 2,
this action will store into memory the closed limit position.
9.
Press button 1, the door will start opening. Release the
button once you are 1 to 2 cm from your desired open limit
position.
10.
Press button 1 briefly. Each press will enable you to inch the
door to your desired closed position. (Press button 4 to
adjust position if necessary).
IMPORTANT WARNING: The garage door will start
closing automatically once step 11 is performed. The door
will also automatically re-open after fully closing with a
short pause between the cycles.
11.
Once you are happy with the position press button 2, this
action will store into memory the open limit position. The
door will now automatically close to its limit position then
fully open to calculate the safety obstruction forces (ISS).
Please be aware of the above warning.
Go to STEP 9 and test the Safety Obstruction Force.
FIG. 14
FIG. 15
INCH OPEN
BUTTON 1
INCH CLOSE
BUTTON 4
SET
BUTTON 2
8.2 RESETTING DOOR LIMITS POSITIONS
The door travel limit positions can be deleted for new
positions by following the steps below:
1.
Press and hold the Close button (
Fig. 16
) for six (6) seconds
until you hear three beeps and the red Close Limit LED
starts to flash. Release the button.
2.
Follow STEP 8.1 to set new travel limit positions.
Important: There is no need to re-code the transmitter used for
setting the limit positions. After the limits are reset the
transmitter will automatically reset to normal operation.
