Automatic Technology GDO-2 SecuraLife, Руководство пользователя

Страница: 15 / 20

CODING TRANSMITTERS
15
STEP 19 - SETTING THE TRANSMITTER TO
OPERATE THE COURTESY LIGHT
The transmitter can be programmed to operate the courtesy
light on the door opener.
1. Press and hold Light Code button ( Fig. 25 ).
2. Press the button on the transmitter you would like to use to
switch on the light for two seconds
3. Pause for two seconds. Press the same button again on the
transmitter for two seconds.
4. Release all buttons to store the transmitter in memory.
5. Press the transmitter button to test if it switches on the light.
19.1. ADJUSTIING COURTESY LIGHT TIME
The preset courtesy light time on the Door Opener is 3 minutes.
This time can be changed as below.
1. Press and hold the Auto Close Time and Force Margin Set
buttons together (Fig. 26) .
2. While holding the two buttons, press the green Open
button (Fig. 26) . Each press will add 10 seconds to the light
time.
3. To decrease the time follow step 1 and press the red Close
button (Fig. 26) . Each press will deduct 10 seconds from the
light time.
4. To recall the factory set default light time press and hold the
Auto Close Time, Force Margin Set and Reset buttons
together for about 2 seconds.
(Fig. 26) .
20. DELETING PROGRAMMED CODES
20.1 DELETING A STORED TRANSMITTER CODE
1.
Select the transmitter you want to delete.
2. Press and hold the Door Code button (Fig. 27) .
3. Press the transmitter button you would like to delete for two
seconds.
4. Pause for two seconds. Press the transmitter button again for
two seconds.
5. Release the Door Code button. The code should now be
deleted. Confirm this by pressing the transmitter button, the
door should not respond.
20.2 DELETING ALL STORED TRANSMITTER
CODES
1.
Turn the power off to the opener.
2. Press and hold the Door Code button (Fig. 27) .
3. Turn the power on again, while holding the Door Code
button. Release Door Code when the Coding LED illuminates.
4. All the stored codes including the courtesy light codes
should now be deleted. Confirm this by pressing the
transmitters previously used to operate the door. The door (and
light) should not respond.
FIG. 26
FIG. 25
FIG. 27
Coding
LED