Automatic Technology GDO-12Hir, Краткое руководство по эксплуатации

Страница: 3 / 6

Light Status Battery
Solid OK
Flashing Replace
No light Replace
3 . 0 C O D I N G A R E M O T E C O N T R O L
The opener can only be operated from remote
controllers that have been programmed into its
memory. Up to 64 remotes can be programmed.
Battery Type: 1 x CR2032.
W A R N I N G ! : The battery is hazardous and must
be kept out of reach of children. The battery can
cause severe of fatal injuries within 2 hours or less
if swallowed or placed inside any part of the body.
If you suspect the battery has be swallowed or
placed inside any part of the body, SEEK
IMMEDIATE medical attention.
S T E P T H R E E
Press repeatedly
tip
S T E P O N E
4 . 0 C H A N G I N G A B AT T E R Y
HOLD
Check Light
Status Table
S T E P T W O
tip
Use screwdriver
to remove scews
and open
S T E P T H R E E
Use non-metallic
object to push
out.
remove
controls cover
S T E P T W O
S T E P O N E
S T E P T W O
Take a pre-coded
remote and press the
button to duplicate
R E M O T E L Y C O D I N G A R E M O T E C O N T R O L
Remotely coding works when you have a
pre-coded remote control and are in range of the
opener.
tip
Use a pen,
HOLD for 2 sec
the middle button
through the
coding hole
S T E P T H R E E
Opener flashes & beeps
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Take new
remote
RELEASE
S T E P F I V E
Press to test
Opener stops flashing &
beeping
S T E P O N E
Press repeatedly till
CODE LED is lit
OR
till all three LED’s are lit
S T E P F O U R
to enter
coding
HOLD
HOLD for 3 sec
HOLD for 3 sec
RELEASE
Release both
buttons
S T E P F I V E
S T E P S I X
Press to test
Then replace controls cover
To exit
coding