Diamond PD
Power Drive
: Instruction Manual
Dominator Tempo & Syncro Instruction Manual
ATS-3AM & ATS-2AM
23
© Copyright 2019
7.4. Service / Warning Indicator
8.2 If You Need a Service Call
If the opener needs a service please call the dealer who installed the garage
door opener (their contact details are usually on a sticker on the back of your
garage door).
8. User Maintenance Instruction
WARNING! Failure to maintain your garage door
may void the warranty on your garage door
operator.
8.1 Door Maintenance
A poorly maintained door could cause fatal / serious injuries or damage
to property.
a. Frequently examine the door, particularly the cables, springs and
mountings for signs of wear, damage or imbalance.
DO NOT USE
if
repair or adjustment is needed since a fault in the installation or an
incorrectly balanced door may cause injury.
b. Fasteners: Check all screws, nuts and bolts to ensure they are secure.
c. Spring Tension: It is natural for springs to lose tension. Should the
door become hard to operate or completely inoperative, contact a
door professional.
d. Guide Tracks: Clean the internal sections of the guide tracks every
3 - 6 months with a cloth dampened with mineral turps or
methylated spirits.
WARNING! Run the Safety Testing procedures
MONTHLY in Section 10 to ensure garage door is
fit for use.
CAUTION: Frequently examine the installation, in
particular cables, springs and mountings, for signs of
wear, damage or imbalance.
DO NOT USE if repair or adjustment is needed since a fault in
the installation or an incorrectly balanced door may cause injury.
Adjustments should only be carried out by experienced
persons, as this function can be dangerous if not performed
under strict safety procedures.
Flashes Issue
Remedy
1
Normal operation (door is fully open)
2
PE is preventing door from moving
Clear away any obstructions. Test Door. If unable to move the door and suspect beam is
faulty, enter Safety Beam Emergency Close by pressing and holding a pre-coded button
on transmitter for more than five seconds and the door will start closing.
3
NOT AVAILABLE
4
Wireless PE battery is low
Change PE Battery
5
NOT AVAILABLE
6
Maintenance is due after pre-set number of
cycles.
Contact dealer to arrange service.
7
Standby battery is faulty
Contact (800) 934 9892 within America for assistance
8
Door was obstructed
Clear away any obstructions and test door opens/closes correctly. (If door is damaged,
contact your door professional)
9
Motor overloaded or stalled
Check the doors operation by disengaging the motor and ensuring the door runs
smoothly. If necessary make door adjustments or contact your door professional.
10
Unit running on battery power
Main light will flash (3) three times at the start of the cycle to indicate opener is running
from battery backup.
Check power supply.
7.4.1 Main Light = Service / Warning Indicator:
Requirements for a service and user warnings are indicated after operation by the main light repeatable flashing OFF a number of times followed by a pause.
The below table identifys the issues and remedies.
7.4.2 Connecting or Disconnecting Accessories:
When disconnecting or reconnecting accessory base station modules (Auto-Lock) press the MODE button repetitively until the GEAR LED is on, the press the
STOP / SET button until the main courtesy light stops flashing.
BEFORE CALLING
you should have the following information to assist in
providing the appropriate service:
1. Has anything happened since the opener last operated OK, e.g. a
storm, a jolt to the door etc.?
2. What is the current light status on the opener?
3. Manually disengage the door (Section 5).
How easy is it to manually open and close the door?
4. What model is the opener? (Model no. information is located at the rear
of the opener)
5. Who installed the opener? (Dealer details should be on a sticker on the
back of your garage door)
6. When was it installed? (If known)
