22
GDO-8V3
Shed Master Instruction Manual
Fig.7.1
7.1 How to Use Your Operator
For maximum efficiency of your operator, your
garage door must be in good operating condition.
An annual service of your garage door by door
professional is recommended.
REPLACE WITH BATTERY CR2032
Fig.7.2
7.1.1 To Operate the opener:
a. Press the programmed transmitter button until your door begins to move
(usually 2 seconds). Make sure you can see the door when you use the
transmitter
(Fig 7.1)
.
b. If you are in a vehicle you should aim the transmitter through your
windscreen as shown.
c. Check that the door is fully open or closed before you drive in or away.
d. If you press the transmitter whilst the door is moving the door will stop.
The next press of the transmitter will move the door in the opposite
direction.
7.1.2 Replacing the Battery: 3V Lithium Battery CR2032.
a. To test the battery is working, press and hold a transmitter button. Check
Light Status table to determine if battery needs replacing
Light Status
Battery Status
Solid
OK
Flashing
Requires replacement
No light
Requires replacement
b. Remove screw from back of cover.
c. Use screw driver to separate the transmitter casing to expose circuit
board.
d. Use a non-metallic object (e.g. pen) to remove the battery.
(Fig. 7.2)
.
CAUTION!
Activate the operator only when the door is in full view,
free of obstructions and with the operator properly adjusted. No
one should enter or leave the garage while the door is in motion.
DO NOT allow children to play near the door.
WARNING! This operator has a grounding type plug and
there are no user serviceable parts inside this operator.
