Automatic Technology Axess Pro Series 3000, Руководство по установке

Страница: 17 / 41

Owner Installation Instructions Axess® Pro Series 3000 17
Setting Limits: Via Transmitter
16
fi g
Axess® Pro 3000 series shutter opener has the alternate
ability to set travel limits using the transmitter, allowing
free movement around the installation site to better
assess the desired limit positions. In order to use a
transmitter, it must fi rst have at least one of its buttons
coded to the door controller. The function assigned to
the transmitter’s buttons is of no concern here as the
buttons are temporally assigned to OPEN, CLOSE and
SET
(Fig. 17) .
Step 7 - Code A Transmitter For Limit Setting
Step 7.1 - Navigating to “code transmitter”
menu
1. Press NEXT to navigate to Menu 1.
2. Press SET to enter the code set procedure
(Fig. 16) .
Step 7.2 - Storing Transmitter Code
1. Controller will prompt to press one of the
transmitter’s button.
2. Press the transmitter button you wish to use to
operate the door opener (e.g. button 1) .
3. Press the same transmitter button again as
prompted by display.
4. Press the set button to store the transmitter.
Step 7.3 - Navigating To “Set Door Travel
Menu”
1. Press PREV to navigate to Menu 10.
2. Press SET to display MENU 10.1.
3. Press SET two times to enter the limit setting
procedure. The close blue LED will start to fl ash.
Setting Limits Via Transmitter
Press and hold Button 4 on the transmitter to close the
door.
If the door opens, release button 4 and press
the stop button once on the wall control unit to
change the direction of the motor. Then press
and hold Button 4 on the transmitter to close
the door.
If the door is closed too far, press Button 1 to
“inch” the door towards open.
When happy with the close limit position, press
Button 2 to store this in the memory. The open
green LED will starts to fl ash.
Press Button 1 to open the door.
If the door is opened too far, press Button 4 to
“inch” the door towards close
WARNING: The door will automatically close
and open once next step is performed. Ensure
that no persons or objects are in the door’s
path.
When happy with the open limit position, press Button
2 on the transmitter to store into memory.The door will
now automatically close and open to calculate the travel
times and other settings. After this, if PE Beams are installed,
then the opener can be operated with the OPEN or CLOSE
button on the wall control unit or from the transmitter.
Otherwise, the controller will be loaded with “Safety Close
Mode”. (Page 29)
»
»
»
Button 1
(Inch Open)
Button 4
(Inch Close)
Button 2
(Set)
MENU 1
Code Transmitter
PR E S S
17 fi g