p 4/58
Technical Manual NAM-BL4x-MT-EN-C
The information in this document is the property of Automatic Systems and is confidential. The consignee withholds from using it for anything other than the use of the products or the execution of the
project to which they belong and withholds from communicating it to third parties without prior written agreement from Automatic Systems. Document subject to change without prior notice.
1. SAFETY WARNINGS
IMPORTANT: SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF INJURY OR DEATH, READ AND FOLLOW
ALL SAFETY INSTRUCTIONS BEFORE INSTALLING, OPERATING, OR SERVICING
THE BARRIER.
SAVE THESE INSTRUCTIONS!
ALL OPERATIONS OF THE GATE MUST BE DONE BY QUALIFIED PERSONNEL. ALL
NON-AUTHORIZED REPAIRS OR REPAIRS DONE BY A NON-QUALIFIED
TECHNICIAN VOID THE WARRANTY OF THE MANUFACTURER.
ALWAYS INSTALL THE ARM BEFORE OPERATING OR LOWERING THE GATE.
UNPIN THE SPRINGS BEFORE PROCEEDING TO ANY ARM INSTALLATION.
Installing a barrier exposes the user to responsibilities with regards to
the safety of people:
Circulation of pedestrians, cyclist and motorcyclist in the area
where the barrier is moving must be banned (risk of being hit
and pinching).
Two pictograms for the prohibition of pedestrian,cyclist and
motorcyclist access are provided with the equipment;
To allow the passage of motorcycles, a special loop
configuration along with photo cells must be used as specified
in the drawing BL229-IN-07-EN. The systems must be tested prior to use.
All operations performed on the equipment must be undertaken by qualified personnel. All operations
that are not authorised or that are carried out on this product by an unqualified technician shall
automatically and ipso jure lead to the denial of the manufacturer
’
s warrantee.
The access keys to the mechanism must only be used by personnel informed about the electrical and
mechanical risks incurred by negligent handling. This person is required to lock the mechanism’s
access door after completing the work.
As soon as the access door to the mechanism is opened, cut the power supply on the circuit
breaker (20, Ch. 2.1. ).
Raise the arm before any work inside
the housing, in order to release the tension in the balancing
springs and avoid the untimely movement of the driving mechanism (Ch. 0).
All internal elements that could receive power or move must be handled with care.
KEEP GATES PROPERLY MAINTAINED
. When servicing, keep the place around the gate secured to
avoid risk of injuries if the gate were to move without warning.
Test the gate operator monthly. It is important to test the gate to ensure that the force of the arm is not
excessive. If the gate is equipped with the safety contact sensor, the gate MUST reverse on contact
with a rigid object or stop dependent on the programming of the sensor. After adjusting the force or the
