18947_ins_alc_wireless_temp_xmtr
Automated Logic Corporation
1150 Roberts Boulevard
Kennesaw, GA 30144
a
LS3-WT
Installation and Operating Instructions
Rev 03/07/2008
Phone: (770) 429-3000
Fax: (770) 429-3001
http://www.automatedlogic.com
Analog Output Module Training
1.
Apply power to the receiver and output modules.
2.
The power LED on the Receiver should light and remain lit. The powered analog output module's LED should
flash and go out. (The flash is very quick.)
3.
Remove the cover of the transmitter and remove battery tabs or install the batteries, observe polarity. (See Figure 1)
The small LED at the bottom right, next to the Transmitter Training Button in Figure 1, should flash approximately
once every 10 seconds. (The flash is very quick.)
4.
Pick a transmitter and an analog output module you want to train to recognize one another. Press and hold the
plastic service button on the top of the Output Module, at the same time press for one second and release the button
on the transmitter. When the LED on the output module lights, release its button (The LED will go out when you
release the button). The output module will now report the environmental conditions from the transmitter trained to
it. The output module's LED will quickly flash whenever it receives an update from the transmitter.
5.
Mount the transmitter at the desired location. If needed, remove the batteries to do so. The units will remain
trained to one another through power failures and battery replacement.
6.
Replace the transmitter's cover and back out the security screws.
Diagnostics
Possible Problems:
Possible Solutions:
Temperature is reading its low
limit
-
Check wire from output modules to controller for proper connections and
polarities.
-
Check to see if the controller's software is configured properly.
-
Check transmitter to see if its LED flashes about every 10 seconds. If not
replace the batteries.
-
Check power to the receiver and output module.
-
Check output modules LED, if it is blinking fast
Check the associated transmitter's batteries
Retrain the modules
Temperature reading is coming out
the wrong output module
-
Retrain the modules.
Temperature is reading incorrectly
-
Check wire from output modules to controller for proper connections and
polarities.
-
Check to see if the controller's software is configured properly.
-
Check to see if the correct output module is connected to the right controller.
Specifications
Supply Power: BA/LI3620.
Two 3.6V Lithium batteries,
5 to 8 year battery life at 10 second transmit rate
Inputs:
Built in thermistor
Accuracy:
±0.2 °C
Transmitted Range:
-40° to 85°C
Environmental Operation Range:
Temp: 0° to 60°C
Humidity: 5% to 95% RH non-condensing
Material:
ABS Plastic
Material Rating:
UL94 V-0
Radio Frequency:
418 MHz or 433MHz
Transmitter Interval:
~10 seconds
Antenna:
Built inside the enclosure
FCC Approval:
FCC ID# T4F16963N16964
(418MHz only)
