AUTOMATED EQUIPMENT McDonald's DF22, Руководство по эксплуатации оборудования

Страница: 10 / 37

DF22 Dispenser
Copyright © 2005 Automated Equipment LLC All Rights Reserved
10
Front Panel System Diagnostics
Power On/Off Illuminated Switch
The power On/Off Switch has an internal light that indicates A.C. power to the Dispenser. When the power is turned
ON, this light illuminates indicating the presence of A.C. power internal to the Dispenser.
If the On/Off Switch is On but not illuminated, check to make sure the power plug is properly connected to the
Dispenser and the wall outlet.
If the plug is connected, check whether the internal Circuit Breaker (SW1) inside the back of the Dispenser has been
tripped.
24 Volt D.C. Power Supply
The
indicator lights
on the Control Panel are powered by the internal 24 volt power supply. After turning the unit On,
pressing one of the Load Size Select buttons will illuminate the
indicator light
associated with this button. This
indicates the presence of D.C. power within the Dispenser.
Drum Motor and Accumulator Drives
Operations of the Drum Motor and the Accumulator Doors can be verified by putting the Dispenser in the Exercise
Mode via the front panel controls.
To enable the Exercise Mode perform the following steps:
1. Turn the Dispenser power switch OFF and Wait 15 seconds.
2. Depress and hold in the Dispense / Reset button while turning the power switch ON.
3. Hold in the Dispense / Reset Button, after approximately 5 seconds, the Dispenser will enter the Exercise Mode.
Release the Dispense / Reset Button. The Drum Motor will turn for 5 seconds and then the Accumulator Doors will
cycle. This cycling will continue until the power switch is turned OFF.
When the Dispenser is turned ON again, the Dispenser will be in Normal Operating Mode.