Autojack AIR100L, Инструкция по безопасности и эксплуатации

Страница: 9 / 20

AIR100L 07
Assembly
1. Before starting to assemble the
equipment
1.1 Check equipment for damage which may
have occurred in transit. Report this
immediately to the carrier used for delivery.
1.2 Assemble and install near the area
intended to be used.
1.3 Avoid long electric wires and air lines.
1.4 Avoid Installing in a damp or wet
environment.
1.5 Check the air is dry and dust free.
1.6 You cannot use the compressor in an
area where work is conducted with sprayed
water.
1.7 This compressor can only be used in
rooms with good ventilation and temperature
of +0 to +40°C.
1.8 Ensure there is no dust, acid, vapors,
explosive gasses or inflammable gases in the
room.
2. Product assembly
2.1 Fitting wheels
Install the compressor feet and support
feet.
2.2 Fitting the oil and oil breather
Before you starting the air compressor
please remove the white oil stopper and add
oil into crankcase.
NOTE: Before starting the air compressor
you must verify oil the crankcase and
install the oil breather as described
below:
a) Place compressor on level ground.
b) Remove the plastic oil stopper the oil fill
hole.
c) Verify oil in the crankcase. If the oil down
to the center of the red dot on the oil sight
glass, slowely pour the oil into the oil fill
hole until the oil level rises to the red dot.
d) Insert the oil breather into the oil fill hole.
Firmly hand tighten the oil breather by
turning clockwise.
NOTE: This compressor uses only SAE20 or
SAE30 non-detergent motor oil.
2.3 Fitting the air filter
a) The plastic air filter is installed into the
cylinder head and fixed with hex bolts.
b) Securely tighten the air filter in place.
Note: Do NOT over tighten air filter.
4.Bolt
5.Washer
6.Sucker
7.Nut