For warranty conditions the adapter shall be installed by a workshop authorized by
Autoadapt. Make sure not to damage the steering wheel while removing the adapter.
The adapter can leave impression marks on the steering wheel.
Determine a suitable position
Make sure that the adapter and the steering knob will not interfere with other
vehicle controls. The adapter shall be placed with the release button facing towards
the steering wheel centre. For individuals using a hand control for accelerator and
brake with their right hand, a suitable position for the steering knob is usually on the
left side (10 o’clock), in left side driven vehicles. In right side driven vehicles a suitable
position, under the same conditions, would be reversed (2 o’clock).
Mounting
Remove the fastening plate (bottom part) by unscrewing the two screws (A). Check
that the adapter fits the steering wheel. If there is a gap, place some rubber material
in between to achieve a snug fit. Adjust the two spacing screws (B) to create a hol-
der-on against the fastening plate. Mount the fastening plate using the two screws (A)
and the locking washers. Be careful to screw correctly into the threads of the holes.
Check-up
Check that the adapter is properly fastened by mounting the steering knob and trying
to move the adapter inwards and out. The adapter shall stay put.
B
A
10
Steering knob adapter
Independent driving
Mounting
