Auto Vox K10, Руководство пользователя

Страница: 6 / 56

3
I
nstallation
Pre-Installation note :
● When installing the unit, do not impair the equipment, control units and systems inside the vehicle. Follow local applicable laws and safety
regulations for vehicles!
● Park in even and safe location.
●
Before installing your backup camera, please test all the components of the product using your vehicle power or an external power supply
to check if the product can work properly.
The test steps for reference:
a. Connect the power cable to the car battery. (The red wire is connected to the positive pole, and the black wire is connected to the negative
pole)
b. Insert the car charger into the cigarette lighter port, turn on the engine and power it on.
c. After the above steps are completed, if the screen displays image normally, it means the product is working normally.
After the test is complete, the installation can be performed.
Installing the monitor
1) Tear off the red sticker from the base of the mount holder and stick it to the dashboard. Press the base against the mounting surface for 15
seconds to ensure the sticker sticks firmly.
● The location of the monitor can not impair the visibility of the driver.
● Clean and dry the area of the dashboard where you would like to mount your monitor.
● The angle of the monitor can be adjusted by moving the monitor from left to right, up to down.
● Do not remove the base after it is glued, as the adhesive tape may lose its stickiness.