• The oven shelf is designed to allow good circulation at the
rear of the oven and are fitted with a raised bar to prevent
trays or dishes making contact with the back of the
oven.To remove the shelf, pull forward until it stops, raise
the front and remove.
• The baking tray and roasting dish provided are the largest
that should be used in the oven as larger items may affect
the circulation and heat distribution.
The cookers are fitted with a thermostat that gives controlled
temperatures throughout the cooking range.The gas mark
relates to the temperature at the centre of the oven, with
higher temperatures towards the top and lower temperatures
towards the bottom.
This variation is approximately equivalent to one gas mark.
These zones can be used to cook, simultaneously, foods that
require different heat settings.
Cleaning
DO NOT USE ABRASIVE
CLEANERS OR POLISHES.
Your new oven will keep its good looks and work efficiently if
the following cleaning instructions are followed.
Painted parts:
Use only a soft cloth with warm soapy water.
Vitreous metal:
Inside the oven, grill compartment and
hotplate only. Use a cleaner recommended for vitreous
enamel or a soap filled pad, i.e. 'Brillo'.
Note:
the oven and grill doors and the cooker trims are
painted and must only be cleaned with warm soapy water.
Chrome parts:
Use warm soapy water or a brillo pad.
Glass:
Use warm soapy water or a mild cream cleaner.
Extractor Hood (If fitted)
This is located above the hob, operation is as follows: Switch
1 works the light and switch 2 the fan.
Leaks
If a smell of gas becomes apparent, turn off supply at
cylinder immediately.
Extinguish all naked lights including cigarettes and pipes.
Do not operate electrical switches. All doors and windows
should be opened to disperse any gas build up.
As butane and propane are heavier than air, the gas will
collect at low level.The strong unpleasant smell will allow the
general area of the leak to be ascertained, check it does not
originate from an unlit appliance. Never check for leaks with a
naked flame; investigation should be carried out using a leak
detector soapy solution.
Maintenance
Little maintenance is necessary for this appliance other than
cleaning. This appliance must not be modified or adjusted
unless authorised and carried out by the manufacturer or
their representative. No parts other than those supplied by
the manufacturer should be used on this appliance.
17
7. Gas: Appliances
Final 2006 AT Handbook 1/12/05 12:06 pm Page 17
