Auto-Sleeper lancashire ek, Руководство пользователя

Страница: 51 / 144

7-27
CONNECTION OF SERVICES
2.2 Activating the System
The EC500 system has a shutdown feature
that should be used when the vehicle is in
storage or is not being used for long periods
of time. This allows the leisure electronics to
be turned off when not required to save
battery power. When in the off state the alarm
and tracking system supplies are still active,
most other supplies are turned off.
Before using the system please ensure the
system shutdown switch is in the on position
(button in).
2.3 Connecting to the Mains 230V supply
and Safety checks
For your safety it is IMPORTANT that you
follow these connections instructions each
time your Leisure Vehicle is connected to a
mains supply. This section assumes that the
system is complete and that a Leisure battery
has been installed (see 3.5).
A) Ensure suitability of the Mains Supply.
Your Leisure Vehicle should only be
connected to an approved supply that
meets the requirements of BS7671 or
relevant harmonised standards. In most
cases the site warden will hold
information regarding suitability of supply.
If using a generator you also need to
comply with the requirements /
instructions supplied with the generator.
Please note that some electronic
generators may not be compatible with
your leisure system. Further generator
operational information is contained
elsewhere in this manual.
B) Switch the PSU internal Power Converter
OFF. Locate the green ‘Charger’ power
switch on the PSU and ensure the switch
is in the off position (button out) before
connection to the mains supply.
C) Connect the Hook-up Lead. Firstly
connect the supplied hook-up lead
(orange cable with blue connectors) to
the Leisure Vehicle and then connect to
the mains supply.
D) Check Residual Current Device
operation. Locate the RCD within the
PSU and ensure the RCD is switched on
(lever in up position). Press the ‘Test’
button and confirm that the RCD turns off
(lever in down position). Switch the RCD
back to the on position (lever in up
position). If the test button failed to
operate the RCD see section 3.14.
E) Check Miniature Circuit Breakers. Locate
the MCB’s within the PSU (adjacent to
the RCD) and ensure they are all in the
on (up) position. If any MCB’s fail to
‘latch’ in the on position see section 3.14.
F) Turn the PSU ON. Locate the black
‘Shutdown’ button and ensure it is in the
on position (press button to change,
button in = on, button out = off). Locate
the green ‘Charger’ switch on the PSU
and turn to the on position (press button
to change, button in = on, button out =
off). The charger switch will illuminate
when turned on.
G) Check correct Polarity. Locate the
‘Reverse polarity’ indicator on the PSU
and ensure that the indicator is NOT
illuminated. If the indicator is illuminated
see section 3.10.
H) Check operation of equipment. It is now
safe to operate the 12v and 230v
equipment.