5.
Fixing the Operator to the Door
Please note: The motor is designed to operate on the right side of the door by default.
To reverse the drive for left hand side installation, press the set
button
and hold until the LED displays “5”.
Using the “UP” and “DOWN” buttons select “1” for left installation
or “0” for right side installation. Hit “SET” to confirm the setting.
Installation process (FIG. 3 through FIG. 5)
1. Remove the U-Bolt off the end of the door that you intend
to install the motor on.
Ensure that the U-Bolt on the
opposite end is firmly fastened first
.
2. Lift the door up and away from the wall until clear of
the door bracket, before lowering the door to rest on
the door stand or prop.
Note: If there is limited ceiling space, the door bracket may
have to be removed. If this is required, use the reference marks
on the wall for correct positioning to ensure that it is both secure
to the wall & able to support the door.
3. Remove the opener from the box.
4. Check that the drive gear rotates freely by hand, by
pulling the disengage handle. Then move the forks
from side to side by hand.
5. Slide the opener over the door axle and into the drum
of the door as shown in Figure 4.
6. Push the opener as far as possible into the roll of the
door (without interfering with the curtain) so one of the
door drum’s wheel spokes
is between the
opener’s
drive forks
. If the forks cannot slide into the drum
wheel, use the supplied extension arms.
7. Raise the door off the door stand or suitable prop.
8. Lift up and over the door bracket and use your
reference marks on the door bracket to position the
door.
9. Refit the U-Bolt and tighten.
10. Remove the safety rope and door stand / prop.
11. Connect the power cord to a suitable power point, but
do not switch on. Secure the power cord away from
any moving object (e.g. the door).
12. With the opener still disengaged, pull the door up and
down to ensure it runs freely.
WARNING! To prevent injury, do not
allow children or other persons near
the door or the prop
