Auto Meter BVA-200EX, Руководство оператора

Страница: 12 / 14

12 17
After the Load Test is completed results similar to one of the following
sample screens will appear.
Battery passes
testing. Return to
service.
Charge battery and place into
service.
Battery did not have a sufficient
charge for a complete Load Test.
Charge and retest.
Battery passes testing but
is marginal. Battery should
be replaced soon. Extreme
temperatures/weather may cause
battery to fail.
4
ALTERNATOR TEST
This test measures the output of the alternator under load conditions.
This information provides the basis for further charging system tests. It
also detects the presence of an open or shorted diode that causes an
output loss of several amps and can cause the failure of other diodes.
Symptomatic Check before Proceeding:
Battery should be in good condition and charged before testing the
Alternator.
Check warning light indications.
Check belt condition and tension.
Check all cables and connections.
Check the battery for corrosion and dirty terminals.
Does the battery have a low state of charge? (See section 2 and 3)
Make sure all electrical items are off.
Check for Alternator noise.
ALTERNATOR TEST
Use the (+Up and -Down) keys
to move cursor to the desired
test.
Start engine.
The BVA-200EX will allow the
voltage to stabilize before
starting the test.
Note: Battery should be in good condition and charged before proceeding
with this test. Press (N Esc.) to return to main menu. Select Alternator
Test then press (Y Enter).
BATTERY TEST
STARTER TEST
>ALTERNATOR TEST
REVIEW/PRINT
>ALLOW VOLTAGE
TO STABILIZE
14.43V
START ENGINE.
‘N’ TO CANCEL
Bar at the bottom of the screen
will show the tests progress.
Be patient it can take up to 30
seconds for the voltage to
stabilize.
Battery did not have
sufficient remaining
capacity to pass tests.
Battery should be replaced
immediately.
BATTERY TEST (cont.)
#32 12V BATTERY
GOOD BATTERY.
12.84V CHG 100%
MEAS CCA 600
#33 12V BATTERY
BAD BATTERY
12.45V CHG 75%
MEAS CCA 600
#34 12V BATTERY
GOOD NEEDS CHARG
12.24V CHG 50%
MEAS CCA 600
#35 12V BATTERY
CHARGE AND TEST
12.06V CHG 25%
MEAS CCA 600
#36 12V BATTERY
MARGINAL BATTERY
12.80V CHG 100%
MEAS CCA 600