auto maskin NMEA2000/J1939, Быстрое руководство по установке

Страница: 9 / 13

Quick Installation Guide
Page 3
Installation of
the Gateway
This chapter covers installation of the
Gateway.
Unpacking the box
The box shall contain the following
material:

1x p/n 1121416 Gateway

1x DIN-rail mounting kit, with two
rail mounts and four countersunk
M3 screws for rails

This manual
Mounting the unit
The unit can either be mounted to a
flat surface using four mounting
screws, or to a DIN-rail using the DIN-
rail mounting kit that comes in the
box.
The unit dimensions and mounting
hole locations are shown on the
following drawing.
Connecting the
NMEA2000® cable
The unit shall be connected to the
NMEA2000® network by the 5-way
micro C socket on the front.
Carefully attach the network drop-
cable to this plug and hand-tighten
until it is fully seated. Take care to
match the orientation of the pip inside
the socket to the recess inside the
drop-cable plug.
The other end of the drop-cable shall
be connected to a suitable T-
connector on the NMEA2000® network
backbone cable.
Note! The NMEA2000® bus shall be a
12V, and not a 24V, powered bus!
Connecting the J1939
CANbus cable
The cables connecting the device to
the J1939 CANbus network shall be
connected to the Wago Cage Clamp
terminal block.