Auto Crane HC-10 NEXSTAR, Руководство пользователя, Страница: 24 / 92

24
NexStar Operation
HC-10 NEXSTAR
Auto Deploy
Auto Deploy allows the operator to move the boom from the home position (usually the cradle) to a
predefined position without having to manually move the boom. From the starting position, the boom will
elevate to a preset angle, rotate to the deployed position, raise to the final angle, then pay out hoist cable,
releasing the hoist block from the stow hook.
The boom present angles, rotation position, and speeds are all preset in the controller.
Check that the path from the home position to the deployed position is clear of
any obstructions, otherwise, equipment damage and/or personal injury could
result.
When deployed, the hoist block will swing outwards.
Auto Deploy will not initiate if the boom is not in the home position.
To initiate Auto Deploy, ensure that the crane is on and operational (power, hydraulics, etc.), fully depress
and hold the trigger, then press the Engine Start/Stop switch up to Engine Start. This should begin boom
motion and the boom will move towards the deployed position. When the boom has reached its final
position, it will cease movement.
To pause the Auto Stow process, release the trigger. To resume motion, depress and hold the trigger. If
the operator attempts any manual boom control during Auto Stow, the sequence will be cancelled, and the
initial conditions will need to be met again.
Keep constant watch on the crane as it moves through the cycle. If the crane
needs to be stopped during automatic movements, release the trigger.
!
CAUTION
!
CAUTION
NOTICE
!
CAUTION