Auto Crane 3203EH, Руководство пользователя

Страница: 31 / 87

4-7.0
MAINTENANCE
OF BATTERIES
If, after charging, it is noted that the specific gravity
reading of one cell is 30 points less than any of the
other cells, it may be assumed that the cell is bad
and that the battery should be replaced. If all cells
are uniform but not up to full charge, a low rate of
charge should be attempted for an extended time.
This usually will recover a badly sulfated battery.
Replacing a Battery
If it is necessary to replace a battery, and a dry
charge battery is used, the following procedure
applies:
1. Fill the battery with electrolyte of the proper
specific gravity.
2. Place the battery on charge according to the
manufacturer's instructions.
It is essential that the second step above be followed to
ensure that the battery going on the vehicle is fully
charged.
It is also very important that the battery hold-downs be
checked periodically to insure that the batteries are
properly positioned to avoid vibration problems,
breakage of cables or terminals. Care must be taken to
avoid cracking or breaking containers or covers by
tightening hold-down fixtures excessively. They also
must not be so loose that breakage results from a
hold-down that is too loose.
8/16/05