Auto Crane 3203EH, Руководство пользователя

Страница: 18 / 87

—-IMPORTANT—-
BEFORE OPERATING CRANE
1. Make sure this manual has been thoroughly
read by all crane operating personnel and
supervisors.
2. A routine inspection of the crane should be
mandatory before each operating day. Any
defects should be corrected immediately.
3. At a job site the vehicle should be positioned
so that the crane can adequately reach the
load within the rated capacity (centerline of
rotation to hoist hook).
4. Keep the vehicle as level as possible during
operation. CANNOT EXCEED 10° SLOPE.
5. For electric cranes, engage emergency
brake and leave ignition on with transmission
in neutral (or in park for automatic
transmissions). Activate any crane power
switches. For Auto Crane units requiring
battery and hydraulic operation,
engage
emergency brake, place gear selector in
neutral, press clutch, activate PTO, release
clutch and after hydraulic fluid is warm, set
throttle control to proper engine speed.
6. Always use outriggers from the truck to the
ground. Be sure these are firm and ade-
quately positioned. When rotating,
keep load
as low to the ground as possible.
7. Remove the transmitter from cab or storage
area. Power transmitter on. Detach hook
from dead man. Crane is now ready for op-
eration.
8. Always boom up before rotating so the boom will
clear the required boom support.
9. When extending the boom, always maintain
clearance between the boom crown and the
traveling block or hoist hook.
10. Always observe safe and practical operation to
avoid possible accidents. Refer to Safety Tips
and Precautions.
11. After completing lifting operations, return the
boom to stowed position on the boom support.
Avoid unneeded pressure on the boom support.
12. Store transmitter in proper location (in cab or
storage area).
13. Return outriggers to stowed position. Make sure
they are pinned in place or jacklegs are returned
to compartment.
14. Check work area for any tools or equipment not
stored.
15. Release throttle control, depress clutch and dis-
engage PTO. Deactivate any crane power
switches.
16. Report any unusual occurrence during crane
operation that may indicate required mainte-
nance or repair.
17. NEVER use two cranes to support a load too
large for either crane.
OPERATION OF OUTRIGGERS
HYDRAULIC OUTRIGGERS
1. Shift crane/outrigger control valve to
"outrigger" position.
2. Operate the outrigger control valves to
position the outriggers.
3. After outriggers are positioned, return crane/
outrigger selector to "crane" position.
4. Crane is now ready to operate.
MANUAL OUTRIGGERS
1. Pull lock pins to release jackleg or drop down
outrigger and move to outermost lock position.
2. Make sure lock pins are reinstalled properly.
3. Lower outrigger pad to firm ground and adjust foot
to take out slack.
4. Crane is now ready to operate.
3-1.0
8/19/05