into the proper slots in the battery compartment.
4)
Proper battery orientation is indicated in the battery
compartment.
5)
Replace the battery compartment and screw using a
screwdriver to close the battery compartment cap.
3.2 The Imager Head and Cable Installation
To use the tool, the imager head and cable must be connected to
the handheld display unit. To connect the cable to the handheld
display unit, make sure the key and slot
(Fig. 6)
are properly
aligned. Once they are aligned, finger-tighten the knurled knob to
hold the connection firmly in place.
Fig. 6
Warning: Ensure to only tighten or loosen the knurled knob and not the
shaft
3.3 Accessories Installation
The three accessories include magnet, hook and mirror
(Fig. 2)
.
All are attached to the imager head in the same manner. Hold the
accessory and the imager head as shown in
(Fig. 7)
, slip the end of
the accessory over the flats of the imager head and then fix the
accessory as shown in
(Fig.8)
.
9
