REAR PANEL
ACCESSORY PORTS
Allows connection of wall panel controllers,
paging stations and audio wall panel inputs.
See the full manual for wiring and setup
instructions.
ZONE OUTPUTS
The ZONEMIX4 has 4 stereo or 4 mono
balanced line level outputs (Software
configurable). The ZONEMIX8 has 8 mono line
balanced level outputs. Balanced male 3-pin
(3.81mm) euroblock connector.
STEREO RCA UNBALANCED INPUT
A standard stereo RCA female socket for each
input. This is summed to mono inside the
ZONEMIX8. The ZONEMIX4 will maintain the
stereo audio path unless mono output mode
is selected.
A -14dB pad can be applied, via software,
using the front panel or PC control software.
Off by default.
XLR MIC AND RCA LINE INPUT, CH1-2
A standard female XLR balanced socket is
provided on each microphone input:
Pin 1 = Signal Ground
Pin 2 = Hot (non-inverting or in phase)
Pin 3 = Cold (inverting or reverse phase)
1
2
3
4
5
6
8
9
7
10
1
2
3
4
5
6
7
8
9
10
MIC GAIN
Provides a rear panel attenuator for Input 1
and Input 2.
GENERAL PURPOSE INPUTS AND
OUTPUTS
Configurable in the PC control software to
perform various control actions.
TONE GENERATOR
Connect any of the EVAC, ALERT, INTRUDER,
BELL and CHIME inputs to the GND input to
play the tone.
RS232
3-pin (3.81mm) euroblock connector for
connection to external control systems.
ETHERNET
Ethernet is used to communicate with the
device over a LAN. The supported network
speed is 100Base-T.
Consult the Network setup section of the full
manual for further details.
POWER INPUT CONNECTOR
Your mixer is powered via a 24VDC 2A
universal power adapter. The power adapter
is included with your mixer. The DC input
accepts a 5.5/2.1mm plug with tip positive
and ring negative connection.
