ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The mixer shall have 6 balanced mic/line inputs and 2 stereo line inputs. The mic/line channels shall be bal-
anced and feature 3 pin female XLR sockets. The stereo line channels shall have dual female RCA sockets.
Each channel shall include tamper resistant treble, bass, and pan controls. The first six channels feature a line
level direct output which can be used to feed additional amplifiers, mixers or recording devices. An internal
jumper shall allow the first six inputs to be removed from the master left/right outputs whilst still retaining
their direct output function. The equalisation per channel shall provide 12dB cut or boost at 100Hz and 10dB
cut or boost at 10kHz. The master section shall include individual level controls for both the Left and Right
outputs and shall also include two 7 segment output level LED meters. The master outputs shall be balanced
3 pin XLR male sockets, and dual RCA female sockets for the stereo tape output. A 1/4” stereo headphone
socket shall be included for monitoring. The mixer shall include muting card, as well as a 4 tone generator.
The mixer shall be of high quality, suitable for both live and commercial applications. It should have ample
headroom and a frequency response of no less than 50Hz - 15kHz (±3dB). Total Harmonic distortion shall be
no more than 0.1% at 1kHz. The S/N ratio shall be -74dBV or better. Phantom Power of no less than 15V DC
shall be available on all microphone inputs. An internal switch to disable the phantom power on any of the
mic/line channels shall also be included. The unit shall be packaged in a rugged 1 RU metal chassis suitable
for desk or rack mounting.
The mixer shall be an Australian Monitor Installation Series model TX8201.
Frequency Response
50Hz - 15kHz (± 3dB)
Total Harmonic Distortion
Less than 0.1% @ 1kHz
Signal To Noise Ratio
-74dBV (all channels at centre position)
Tone Controls
Bass @ 100Hz - Boost +12dB, Cut -12dB; Treble @ 10kHz - Boost +10dB, Cut -10dB
Inputs
6 active balanced mic/line inputs with 3 pin XLR female sockets (200 - 600 Ohms).
Maximum Input Level is 500mV. 2 Stereo Line inputs with dual female
RCAs (47K Ohms). Maximum Input Level is 1.5V.
Input Sensitivity
Mic: 1mV @ 200 Ohms; Line: 150mV @ 47K Ohms
Phantom Power
15V DC on all mic channels (switchable)
Outputs
Left & Right Master Outputs, 3 pin XLR male sockets. (1.5V @ 600 Ohms.)
Maximum Output Level: +20dB Stereo Headphone Output, 1/4” stereo socket.
(3.5V @ 600 Ohms) Stereo Tape Output, dual female RCA connectors.
(400mV @ 10K Ohms). Six direct line level outputs (600mV @ 10K Ohms)
Controls
Level Control per channel, Recessed Treble, Bass and Pan Controls per channel,
Left and Right Master Level Controls
Indicators
Power “on” orange LED, 7 segment LED meters for both L and R outputs
Power Source
120VAC 60Hz 3 pin IEC connector
Power Consumption
7 Watts
Dimensions/Weight
1.75" H x 19" W x 9.85" D (Chassis dimensions only). 8.8lb
UL APPROVED
PO Box 3126, Lynnwood, WA 98046
• Voice:
425-673-5175
• Fax:
425-673-7825
• Website:
www.australianmonitor.com
• Email:
AUSTRALIAN MONITOR AUDIO INC.
