ALC UIM LB L-3 1210xx/1211xx/1213xx_19
After use
1.
Be sure to leave the lever block in non-idling condition (See To
Termination of Idling on previous page).
2.
Wipe dirt and water off and apply lubricant to the chain, the revolving
parts, the hook, the retaining pawl shaft, etc.
3.
To store the lever block, hang it up in a dry place, away from the
excessive dust and harsh chemicals.
Inspection and maintenance
If flaws such as (elongation, deformed, wear, cracks, bend, etc ) are
discovered, replace the faulty parts with new genuine Austlift parts.
1.
Check to see if the chain, end and bottom hook have been damaged.
2.
See if the handle, grip ring, push ring, brake plate, retaining plate, hub
etc. have been damaged, check, also, to see if in an idling operation the
retaining plate and pawl have excessive rattle.
3.
Check to see if the gear cover, gear ,side plate 1, top hook, hook, pin,
guide, load sheave, pinion shaft or side plate 2 has been damaged.
4.
In assembling, wash all parts well with degreaser. The teeth on the
center line of two marks at the B gear spline, should be disposed, across
the 1 in the inner/outer, arrangement in the case of the 0.75T model,
in the inner/outer relation in the case of 3-ton model, and in the free
position for the 1.5T model.
how to disassemble the lever block
(See Illustration of Parts on page 10)
1.
Disconnecting the chain; Set the end apart and slip the chain out in
idling condition (See step B on the previous page.)
2.
Disassembly of the handle and brake; Disassemble from the right-hand
side of Illustration of Parts.
3.
Disassembly of the gear and center; Disassemble from the left-hand
side of Illustration of Parts.
4.
Reassembly; Assemble in the order of part numbers in Illustration of
Parts.
12
Australian Lifting Centre
USER INS
TRUCTION MANU
AL
SERIES LEVER BL
OCK L
-3 SERIES
ST
ANDARD/
O
VERL
O
AD PRO
TECTION
